Saturday, 19 November 2016

ISTQB Dumps foundation level


Below are few more mock question which is important for preparation of ISTQB foundation level.

1:How many more test cases are required?

A. One more test case will be required for 100 % decision coverage.
B. Two more test cases will be required for 100 % statement coverage, one of
which will be used to provide 100% decision coverage.
C. None, existing test cases can be used.
D. One more test case will be required for 100" statement coverage.

2: A thermometer measures temperature in whole degrees only. If the temperature falls below 18 degrees, the heating is switched off. It is switched on again when the temperature reaches 21 degrees. What are the best values in degrees to cover all equivalence partitions?

A. 15, 19and 25.
B. 17, 18and 19.
C. 18, 20 and 22.
D. 16, 26 and 32.

3: Which activity in the fundamental test process creates test suites for efficient 
test execution?

A. Implementation and execution.
B. Planning and control.
C. Analysis and design.
D. Test closure.

4: Which of the following is TRUE?

A. Confirmation testing is testing fixes to a set of defects and Regression testing is testing to establish whether any defects have been introduced as a result of changes.
B. Confirmation testing is testing to establish whether any defects have been introduced as a result of changes and Regression testing is testing fixes to a set of defects.
C. Confirmation testing and Regression testing are both testing to establish whether any 
defects have been introduced as a result of changes.
D. Confirmation testing and Regression testing are both testing fixes to a set of defects

5: What is the MAIN benefit of designing tests early in the life cycle?

A. It is cheaper than designing tests during the test phases.
B. It helps prevent defects from being introduced into the code.
C. Tests designed early are more effective than tests designed later.
D. It saves time during the testing phases when testers are busy.

6: Which of the following benefits are MOST likely to be achieved by using test 

i) Easy to access information about tests and testing.
ii) Reduced maintenance of
iii) Easy and cheap to implement.
iv) Greater consistency of tests.
A. ii and iv
B. ii and iii
C. i and iv
D. i and iii

7: What is the KEY difference between preventative and reactive approaches to 

A. Preventative tests and reactive tests are designed as early as possible.
B. Preventative tests are designed early; reactive tests are designed after the software has been produced.
C. Preventative testing is always analytical; reactive testing is always heuristic.
D. Preventative tests are designed after the software has been produced; reactive tests are designed early in response to review comments.

8: What is the purpose of exit criteria?

A. To define when a test level is complete.
B. To determine when a test ha
s completed.
C. To identify when a software system should be retired.
D. To determine whether a test has passed.

9: What determines the level of risk?

A. The cost of dealing with an adverse event if it occurs.
B. The probability that an adverse event will occur.
C. The amount of testing planned before release of a system.
D. The likelihood of an adverse event and the impact of the event.

10: With which of the following categories is a test comparator tool USUALLY 

A. Tool support for performance and monitoring.
B. Tool support for static testing.
C. Tool support for test execution and logging.
D. Tool support for the management of testing and tests.

11: Which activities form part of test planning?

i) Developing test cases.
ii) Defining the overall approach to testing.
iii) Assigning resources.
iv) Building the test environment
v) Writing test conditions.
A. i, ii & iv are true, iii & v are false.
B. ii & iii are true, i, iv & v are false.
C. iv & v are true, i, ii & iii are false.
D. i, ii & iii are true iv & v are false.

12: Match the following terms and statements.

1.Decision Table Testing
2.Decision Testing
3.State Transition Testing
4.Exploratory Testing

W. Testing carried out w boxes to achieve specific test objectives, possibly to complement structured testing.
X. A test technique used which may be used to verify different system re depending on current conditions or previous history.
Y. A test technique which combines combinations of inputs that might not otherwise have been exercised during testing.
Z. A form of control flow testing based on decision outcomes.

A. 1Y, 2Z, 3X, 4W.
B. 1X ,2W, 3Z, 4Y.
C. 1Z, 2X, 3W, 4Y.
D. 1Z, 2Y, 3X, 4W.

13: Which type of test design techniques does the following statement best describe a procedure to derive test cases based on the specification of a component?

A. Black Box Techniques.
B. White Box Techniques.
C. Glass Box Techniques.
D. Experience Based Techniques

14: Which is not a testing principle

A. Early testing
B. Defect clustering
C. Pesticide paradox
D. Exhaustive testing

15: The ___________ Testing will be performed by the people at client own 

A. Alpha testing
B. Field testing
C. Performance testing
D. System testing

Stay tuned for more ISTQB dumps and mock questions,

ISTQB dumps, ISTQB mock, ISTQB foundation level, ISTQB Preparations